Short Answer: To enable automated assembly of silicone seals, the feeding orientation, gripping surfaces, deformation control, positioning references, and inspection features should be considered during the product design phase. Soft, […]
Short answer: Micro liquid silicone rubber injection molding places higher demands on metering accuracy, mold venting, parting line clearance, and automated part removal. Small dimensions do not equate to a simple process; even the slightest short shot or
Short answer: Freeze trimming uses low temperatures to make thin flash brittle, which is then removed by jet blasting or rolling. It is suitable for small-batch parts and regular, thin flash, but cannot replace proper
Sealing failures of charging piles, energy storage cabinets, outdoor power supplies, and other equipment mostly occur in the scenario of "temperature, humidity, heat, ultraviolet, and assembly deviation" superimposed on each other. In this paper, a reusable
This article is aimed at procurement, structural engineers and project managers, systematically organizing material routes, key indicators, structural tolerances and verification logic, and providing information that can be directly used for project evaluation.
Flame retardant silicone is widely used in new energy and electrical equipment, but "flame retardant" is not the same as "safe". This article analyzes the differences between UL94 and Scorch Wire testing, and gives an itemized list of the most common flame-retardant silicones used in electrical equipment.