Gate Vestiges on Silicone Sealing Faces: Location and Trimming
Review gate locations against sealing, touch and appearance zones. A remnant acceptable on a nonworking face is not automatically acceptabl…
Read the article →Chengxin Silicone Rubber · Engineering and application insights
Silicone Rubber Knowledge
Explore articles on material selection, structural design and sample acceptance to help address your product questions.
Browse by engineering question
Read the technical guidance, or discuss your drawings and operating conditions with us.
Submit Customization Request →
Slow Recovery of Silicone Pads: Unloading Time and Duty Cycle
Report recovery with elapsed time after unloading, temperature and restraint. Immediate rebound and long-term residual deformation are diff…
Read the article →
Friction Noise from Silicone Bumpers: Slip, Surface and Preload
Identify relative sliding, stick-slip and adjacent-part impacts before blaming the rubber compound for noise near a bumper.
Read the article →
Variable Silicone Plug Pullout Force: Direction, Speed and Depth
Compare retention at fixed insertion depth, dwell and pull direction. Angled pulling, twisting and straight axial removal are different act…
Read the article →
Silicone Covers Causing False Button Inputs: Preload and Position
Check resting button preload and operating reserve after the cover is installed. Free-state hole alignment does not establish position or t…
Read the article →
Thin Silicone Covers Tearing During Removal: Openings and Grip Points
Review opening size, inversion motions and local transitions when thin covers tear. A higher tear-strength specification alone may not solv…
Read the article →
Split Silicone Grommets: Cable Protection Versus Water Sealing
A split eases installation around an existing harness but interrupts continuity. Cable abrasion protection, dust protection and water seali…
Read the article →
Cable Breaks Despite a Silicone Boot: Bend Transition and Strain Relief
A boot should distribute bending over a suitable length rather than move the concentration to its tip. Observe the bend origin and fixing i…
Read the article →
Silicone Grommet Retention in Sheet Metal: Groove and Panel Thickness
Match the retaining groove to panel thickness and opening, not just the cable bore. Thickness limits, burrs and edge shape affect insertion…
Read the article →
Adhesive-Backed Silicone Feet Detaching: Failure Layer and Load
Record the failed layer and whether loading involved peel, shear or impact. 'Weak glue' is insufficient for deciding on tape or surface pre…
Read the article →